Working Flow of PS Fast Food Box Thermoforming Machine
PS Foam Food Container Thermoforming Machine
Introduction:
The PS Foam Food Container Thermoforming Machine is an all powerful thermoforming and vacuum forming machine. It mainly use the PS Foam Sheet Which extruded from the PS Foam Sheet Extruding Machine as the raw material to produce different container,box,tray,dishes and bowl etc. By changing different mold you can get different products.
Working Flow:
Firstly, loading the ps foam roll on the Auto Feeding Device and the Sensor control the feeding. The feeding length can be adjusted; Then the PS Foam Roll enter into the Forming Machine, going through preheating and heating by the Far Infrared Radiation Tile and get the second foam. In the forming System, there is one set mold installed. The Hydraulic Station ,Vacuum and Air is controlled by the PLC .The PLC can control all the full machine work such the chain drive speed and the sheet entering speed, the mold move up and down, the speed of the vacuum from vacuum pump and air from air compressor. All the temperature are showed on the temperature control cabinet to confirm the temperature good enough to form. Then it realize the vacuum forming and thermoforming. After forming,there is cutting off unit at the back of the forming unit. The cutting off mold is installed and through the up and down of the cylinder to realize the cutting.
Tear Apart Design:After Cutting off and thenCut the total PS Formed Sheet to pack it into one big pile. Then use labor to tear apart it to single unit food box and pack to the plastic bags.
Robot Design:After Cutting off then there is the mechanical hand like a robot to grab the PS Foam food box and put it on the worktables then the labor pack to the plastic bags.