What do you need to prepare for the New PS Fast Food Container Project?
With the rapid development of life, more and more people tend to eat fast food, then the fast food box will emerge. "Food for the people", so the fast food box as a load of food, there will be a very long-lasting market, many investors after the market research to invest in fast food boxes project.Tthen what do you need to invest in this project? As PS foam fast-food box equipment manufacturers, we have the following recommendations:
1. Investigate the market, according to the needs of the market to develop product specifications and production capacity requirements, so as to select the appropriate machine models and purchase machines.
Generally in response to different market needs, our equipment will have different models, different prices, to meet the needs of investors. High production requirements, it is recommended fully automated, high yield, high degree of mechanization of equipment. Production requirements are relatively low, it is recommended low yield, semi-automatic equipment.
Note: After the survey, know their needs, but many investors want to invest in this project, but because of limited funds, discouraged. Under such circumstances, can be based on existing funds, select small models of semi-automatic equipment, start small, the accumulation of funds, and then expand production capacity, and gradually expand the market.
2. Prepare the workshop
The establishment of the plant or rent, but also need to buy equipment according to the model or market prospects to set. If the purchase of equipment production is relatively large, the size of the device itself will be relatively large, but also set aside the finished product and the office and so on. In view of the prospect of future market requirements, you can prepare a large workshop to adapt to the future to buy more machines to produce more products. Plant to maintain ventilation, prohibition of fireworks, the surface moist the best.
3. Prepare water, electricity and gas
Water, electric is the most basic preparation, in accordance with local requirements and the power requirements of electrical equipment. Water, as long as the extruder cycle cooling. Gas, mainly butane gas or kitchen gas, etc., as a foam agent.
4. Raw materials and accessories
PS foam fast food box is the raw material of GPPS, general-grade polystyrene, and sometimes in order to increase the product's toughness and strength, you can add some HIPS, high-strength polystyrene, these raw materials are mainly used in the production of PS foam sheet, In addition to its auxiliary materials for butane gas foam, the need to add the right amount of talc. At least 8-10 tons of raw materials to prepare for normal production.
5. Technicians and general operator
Typically, each production line will require a technician and an appropriate number of ordinary operators. Automatic use will be less, more semi-automatic use of some.
For technicians and general operators, after the purchased machine arrives at the factory, we will arrange the engineer to assist the installation and debugging, training the technical personnel.
6. Air compressors, cooling towers and butane gas cylinders
General equipment does not bring these auxiliary equipment, need to prepare.